Electric Soldering

Anti-static, powerful suction, light weight Aluminum construction desoldering pump

Spring-loaded plunger quickly removes solder in a single action.  Tools easily disassemble for fast cleaning.

It is easy to use, simply depress the plunger, place the tip of the nozzle against the solder you wish to remove. When the solder melts, push the release button and a retracting plunger creates a strong vacuum at the tip, removing the melted solder.

Anti-static, powerful suction, light weight Aluminum-plastic construction desoldering pump

Spring-loaded plunger quickly removes solder in a single action.  Tools easily disassemble for fast cleaning.

It is easy to use, simply depress the plunger, place the tip of the nozzle against the solder you wish to remove. When the solder melts, push the release button and a retracting plunger creates a strong vacuum at the tip, removing the melted solder.

Anti-static, powerful suction, light weight plastic construction desoldering pump

Spring-loaded plunger quickly removes solder in a single action.  Tools easily disassemble for fast cleaning.

It is easy to use, simply depress the plunger, place the tip of the nozzle against the solder you wish to remove. When the solder melts, push the release button and a retracting plunger creates a strong vacuum at the tip, removing the melted solder.

• Cordless/simple/and safe operate under any conditions any where
• ready to use 15 sec after ignition
• tank fuel capacity for 120 minutes of operation
• Comes with soldering tip and protective cap

• Equivalent to a power range from 30-100Watt
• Approximate temperature soldering tip: 250~500 C
• Gas container capacity: 20ml
• Operating Time: Approx. 120 min

Advanced quality ZJ-18

• High intensity
• Good immersion
• Neutral ph7+/- 0.3
• Non-corrosive
• Good insulation
• Smooth welding surface
• Non-deteriorating
• Non-drying

Instructions:

• Install a proper size IC suction header
• Place the suction header level on IC
• Squeeze the suction pen to let out the air within the vacuum unit, then release to produce vacuum suction force to pick up IC
• Squeeze the vacuum unit discharging air to let the IC fall off the suction header

• 1 x Glue gun (Comes with  6 x Glue tube)
• 1 x Craft knife (Comes with 5 x Craft Blades)
• 1 x 15cm Ruler
• 1 x Tweezers
• 1 x Spring scissors

• CE certificate